ABB PSTX Series Installation And Commissioning Manual page 122

Low supply voltage fault
7.19.2.3
Low supply voltage fault is signaled if the control supply
voltage is too low. The Softstarter will stop the motor.
Low supply fault has these parameters:
Parameter
26.05 Low supply voltage out
26.06 Low supply voltage op
High current fault
7.19.2.4
A fault signal will be given if the motor current exceeds
the fixed set level which is 8*Ir for the duration of the
fixed set time which is 200 ms.
High current fault is configured with the following
parameters:
Parameter
26.07 High current out
26.08 High current op
Faulty usage fault
7 7.19.2.5
Faulty usage fault is on if the user tries to use motor
heating, stand-still brake and slow speed functions when
the motor is connected inside delta.
Faulty usage fault has these parameters:
Parameter
26.09 Faulty usage out
26.10 Faulty usage op
Connection fault
7.19.2.6
Connection fault signals a fault when a faulty connection
is detected for each type of connection, in line and inside
delta
Connection fault has these parameters:
Parameter
26.11 Faulty connection out
26.12 Faulty connection op
122 Functions | Installation and commissioning manual |
Description
Identifies the Event groups this
fault is part of.
Sets the operation of this fault.
Description
Specifies the Event groups this
fault belongs to.
Sets the operation of this fault.
Description
Identifies the Event groups this
fault is part of.
Sets the operation of this fault.
Description
Identifies the Event groups this
fault is part of.
Sets the operation of this fault.
1SFC132081M0201
Setting range Default value
Eventgroup 0 ... 6 0000001
Stop manual, Stop Stop manual
auto
Setting range Default value
Eventgroup 0 ... 6 0000001
Stop manual, Stop Stop manual
auto
Setting range Default value
Eventgroup 0 ... 6 0000001
Stop manual, Stop Stop manual
auto
Setting range Default value
Eventgroup 0 ... 6 0000001
Stop manual, Stop Stop manual
auto