ABB PSTX Series Installation And Commissioning Manual page 35

Installation Movable HMI
4.2.6.1
INFORMATION
Do not use shielded RJ45 cables. Use a cable
length of maximum 3m to reduce distortion of the
communication.
INFORMATION
The Softstarter HMI is IP66 approved when
installed on the enclosure door.
You can use the movable HMI to copy parameters
from one Softstarter to another during commissioning
(temporarily handheld).
Included with the Softstarter comes:
• Rubber gasket
• Plastic screw-nut
• RJ45 Network cable
1. To remove the movable HMI from the Softstarter,
loosen the plastic latch below the movable HMI,
1 2
see and in Figure 4.9.
2. Drill a hole where to attach the movable HMI.
Maximum dimension of the hole is Ø26 (Ø 1.02"),
see 1 in Figure 4.9. Put the rubber packing
around the threaded network connector on the
2
movable HMI, see
threaded network connector through the drilled
hole.
See 3 in Figure 4.9. Fasten the plastic screw-nut
on the threaded network connector, with 2 Nm
(17.7 lb/in).
3. Remove the RJ45 plug see
the network cable to the network port on the front
of the Softstarter 5
4. Connect the other end of the network cable to the
network port on the back of the movable HMI, see
6
in Figure 4.11.
5. Make sure that the network cable is properly
inserted into the 2 ports. Prevent the rest of the
cable to get caught between the door, see
Figure 4.12. Close the door of the enclosure and
set the operation voltage switch to ON. Make sure
that the external HMI works.
in Figure 4.9. Push the
4
. Connect one end of
in Figure 4.10.
7 in
1SFC132081M0201
1
2 Nm (17,7 lb.in)
Figure 4.9
Drill a hole for the detachable keypad
Figure 4.10
Connect one end of the network cable
6
Figure 4.11
Connect the other end of the network cable
7
Figure 4.12
Roll the rest of the hanging cable
| Installation and commissioning manual | Installation
2
3
Ø26 (Ø 1.02")
5
4
35
4