Serializer Interface Description; Diag Port Setting %Diagportsel; Command Syntax; Description - Huawei EM770W At Command Interface Specification

7

7.1 Diag port setting %DIAGPORTSEL

7.1.1 Command Syntax

Command
%DIAGPORTSEL=<n>
%DIAGPORTSEL?
%DIAGPORTSEL=?

7.1.2 Description

The SET command of this command is used to set the active diag port. The READ
command is used to read the current set port value. The TEST command is used to
return the value range of the set port value.

7.1.3 Defined Values

<n>:
0
1
Issue 18 (2009-06-22)

Serializer Interface Description

UART3(Default value)
Diag port of USB
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>%DIAGPORTSEL:<n><CR><LF><CR><LF>
OK<CR><LF>
<CR><LF>%DIAGPORTSEL:(list of supported <n>s)
<CR><LF><CR><LF>OK<CR><LF>
AT Command Interface Specification
Page 99 of 169