Enable Sleep Mode %Sleepmode; Command Syntax; Description; Defined Values - Huawei EM770W At Command Interface Specification

3.37 Enable Sleep Mode %SLEEPMODE

3.37.1 Command Syntax

Command
%SLEEPMODE=<flag>
%SLEEPMODE?
%SLEEPMODE=?

3.37.2 Description

This command is used to let module enter the sleep mode. After we send
"AT%SLEEPMODE=1", the module will go in sleep mode to save power.

3.37.3 Defined Values

< flag >: sleep flag
Issue 18 (2009-06-22)
0 disable
1 enable
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>%SLEEPMODE:<flag><CR><LF>
<CR><LF>%SLEEPMODE:(range of < flag> )
<CR><LF><CR><LF>OK<CR><LF>
Page 51 of 169