Sim State Change Indication %Simst; Command Syntax; Interface Description; Defined Values - Huawei EM770W At Command Interface Specification

4

11.4 SIM state change indication %SIMST

11.4.1 Command Syntax

Command

11.4.2 Interface Description

When the USIM card state changes, the MS will report the new state to the TE. At the
same time, report the lock state of USIM card.

11.4.3 Defined Values

<sim_state>: USIM card state. The values are as follows:
0
1
2
3
4
255 USIM card is not existent,

11.5 System mode change event indication %MODE

11.5.1 Command Syntax
Command
11.5.2 Interface Description
When the system mode or sub-mode changes, the MS will report this indication to the
TE.
11.5.3 Defined Values
<sys_mode>: System mode. The values are as follows:
0
1
Issue 18 (2009-06-22)
Power-saving and deep sleep state
Invalid USIM card state or pin code locked
Valid USIM card state
USIM is invalid in case of CS
USIM is invalid in case of PS
USIM is invalid in case of either CS or PS
No service.
AMPS mode (not in use currently)
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Possible response(s)
<CR><LF>%SIMST:<sim_state>
Possible response(s)
<CR><LF>%MODE:<sys_mode>[,<sys_submode>]<C
R><LF>
Page 119 of 169