Defined Values; Send Message Sms Mo +Mmc; Command Syntax; Description - Huawei EM770W At Command Interface Specification

5.18.3 Defined Values

<n>:
0
1 keep enabled until the time between the response of the latest message send
command (+CMGS, +CMSS, etc.) and the next send command exceeds 1-5 seconds
(the exact value is up to ME implementation), then ME shall close the link and TA
switches <n> automatically back to 0
2 enable (if the time between the response of the latest message send command and
the next send command exceeds 1-5 seconds (the exact value is up to ME
implementation), ME shall close the link but TA shall not switch automatically back to
<n>=0)

5.19 Send Message SMS MO +MMC

5.19.1 Command Syntax

Command
+MMC<del>SMSMO<del><rcv_
number><del>[<call_back>]<del
><msg><CR>

5.19.2 Description

The command used to send MO message as the special format. If the SMS has been
sent successfully, it should return SENDING SUCCESS value to TE. Otherwise, it
returned SENDING FAIL value to TE for sending failed.
5.19.3 Defined Values
<del>: space
<rcv_number>: Recipient number
<call_back>: Callback number(optional)
<msg>: Message, each byte of msg has to have the code larger than 0x1F, so it will
be available with 0x20

5.20 Received Message Reported Directly

5.20.1 Command Syntax
Issue 18 (2009-06-22)
disable
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Possible response(s)
<CR><LF>+MMC
SMSMO<CR><LF>OK<CR><LF>
After sending:
<CR><LF>SENDING
for success
<CR><LF>SENDING
sending failed
SUCCESS<CR><LF>
FAIL<CR><LF> for
Page 87 of 169