Resume User Settings Z; Command Syntax; Interface Description - Huawei EM770W At Command Interface Specification

In this table, these are several commands we have not describes in this document.
Detailed descriptions can be found in other references for these basic commands.
NOTE: The parameters of %AUTORESET, %IPCTRIP, %IPCFL commands are
stored in NV directly by setting commands. They are not stored by &W command.

3.27 Resume user settings Z

3.27.1 Command Syntax

Command
Z

3.27.2 Interface Description

Set command resumes the user settings which are stored by AT&W command.
The commands and parameters which can be resumed are as follows:
Issue 18 (2009-06-22)
E
V
Q
X
&C
&D
&S
+IFC
\\V
S0
S7
S10
+ICF
+IPR
Possible response(s)
<CR><LF>OK<CR><LF>
In case of MS-related error:
<CR><LF>+CME ERROR: <err><CR><LF>
Command
E
V
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
<Value>
<Value>
<Value>
<Value>
<Value>
<Value>
<Value>
<DCE_by_DTE>,<DTE_by_DCE>
<Value>
<n>
<n>
<n>
<Format>,<Parity>
<Value>
Parameter
<Value>
<Value>
Page 43 of 169