Auto Answer % Autoanswer; Command Syntax; Description; Defined Values - Huawei EM770W At Command Interface Specification

2 fax
<mpty>:
0 call is not one of multiparty (conference) call parties
1 call is one of multiparty (conference) call parties
<number>: string type phone number in format specified by <type>
<type>: type of address octet in integer format
<alpha>: string type alphanumeric representation of <number> corresponding to the entry
found in phonebook; used character set should be the one selected with command Select
TE Character Set +CSCS. Not support.
<priority>: Not support for the moment.

4.8 Auto Answer % AUTOANSWER

4.8.1 Command Syntax

Command
%AUTOANSWER=<n>
%AUTOANSWER?

4.8.2 Description

This command is used to
1. MS can answer a call automatically without reseting the module.
2. The function of auto-answer will be reserved after module reset.

4.8.3 Defined Values

<n>: 0~255
Disable the function of AUTOANSWER
None-zero MS will answer the call automatically after Ring n times.
Issue 18 (2009-06-22)
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>%AUTOANSWER:<n><CR><LF>
<CR><LF>OK<CR><LF>
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Page 56 of 169