Defined Values; Result Code Suppression Q; Command Syntax; Interface Description - Huawei EM770W At Command Interface Specification

3.33.3 Defined values

<DCE_by_DTE>
Specifies the method used by the TE when receiving data from the TA.
0: none
1: XON/XOFF, terminate flow control in the Cellular Engine [NOT SUPPORTED]
2: RTS line (Default)
3: XON/XOFF, evaluate flow control in the Cellular Engine and pass it through
(over the air) to the opposite TE [NOT SUPPORTED]
<DTE_by_DCE>
Specifies the method used by the TA when receiving data from the TE.
0: none
1: XON/XOFF [NOT SUPPORTED]
2: CTS line (Default)

3.34 Result Code Suppression Q

3.34.1 Command Syntax

Command
Q[value]

3.34.2 Interface Description

This command sets whether or not the TA transmits result code to the TE.
3.34.3 Defined Values
<time>:
0
1
NOTE: ATQ will set value to 0.
Issue 18 (2009-06-22)
DCE transmits result code.(default)
Result codes are suppressed and not transmitted.
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Possible response(s)
<CR><LF>OK<CR><LF>
In case of MS-related error:
<CR><LF> ERROR<CR><LF>
Page 49 of 169