Table of Contents
Advertisement
"TCP"
"UDP"
<dest_ip>: string type, IP address to be connected
<dest_port>: 16-bit integer type, Port of the IP address to be connected
<local_port>: 16-bit integer type, local port
13.14 PDP authorization setting command
%IPQCPDPP
13.14.1 Command Syntax
Command
%IPQCPDPP=<cid>[,<
PDP_AUTH_type>[,<pa
ssword>[,<username>]]
]
%IPQCPDPP?
%IPQCPDPP=?
13.14.2 Description
A group of setting authorization indexed by <cid> are stored locally. Each stored
setting authorization contains a group of parameters related to PDP. The SET
command stores a group of PDP-related parameters to the setting authorization
indexed by <cid>. Initially, each setting environment is not defined. After a group of
parameters are stored via the SET command, the setting authorization enters the
"defined" state. The number of defined setting authorization that can be stored
depends on the value range of <cid>.
A special SET command "%IPQCPDPP= <cid>" will clear all parameters in the setting
authorization indicated by <cid>.
The READ command returns all the parameter values of the defined setting
authorization. The setting authorization are displayed by means of linefeed.
13.14.3 Defined Values
<cid>:
Issue 18 (2009-06-22)
the link type is set to TCP
the link type is set to UDP
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>%IPQCPDPP:
[<username>]
[<CR><LF>%IPQCPDPP: <cid>, <PDP_AUTH_type>,
[<username> ][...]]<CR><LF><CR><LF>OK<CR><LF>
<CR><LF>%IPQCPDPP:
<cid>s),(range
supported<PDP_AUTH_type>s),,<CR><LF><CR><LF>O
K<CR><LF>
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
<cid>,
<PDP_AUTH_type>,
(range
of
supported
of
Page 142 of 169
Advertisement
Table of Contents
