Huawei FusionModule1000A20 Installation Manual page 66

It solution

Hide thumbs Also See for FusionModule1000A20:

Table of Contents

FusionModule1000A20 IT Solution

Installation Guide (2016.05, AI Version)

Skill requirement: skilled technician, common technician

Procedure

Step 1 Determine the dehumidifier installation position based on the cooling device layout diagram.

Step 2 Secure the lugs of the dehumidifier on both sides of the chassis, and place the dehumidifier on

the bottom tray in the cabinet. Then secure the dehumidifier lugs to the cabinet rack rail.

Figure 9-17 Installing a dehumidifier

Step 3 Determine the position of the pagoda connector port reserved for the dehumidifier on the

drainpipe under the raised floor by referring to the cooling device layout diagram.

Step 4 Remove the raised floor, clip the dehumidifier drainpipe to the pagoda connector reserved

under the floor using a Phillips screwdriver and a hoop, and open the ball valve connected to

the pagoda connector.

Step 5 After connecting pipes, reinstall the raised floor.

Step 6 Connect one end of the adapter delivered with the dehumidifier to the dehumidifier power

cable, and connect the other end to the circuit breaker reserved for the dehumidifier in the

PDC.

----End

Follow-up Procedure

Verify that the dehumidifier is reliably installed.

Issue 02 (2017-01-10)

For the diagram, see the quick installation guide for the solution in use.

Huawei Proprietary and Confidential

9 Installing Devices Inside Containers

Table of Contents