Figure 8-53 Inserting The Transceiver Tap Frame And Coaxial Cable; Figure 8-54 Drilling A Conductor Probe Hole In A Coaxial Cable - Hitachi S10mini User Manual

8 APPENDIXES
Insert the tap frame to ensure that the coaxial cable is positioned at the center of the
shield pressure-connecting pin. If the cap screw is extremely tilted when tightened to a
certain extent, loosen tighten the screw, center the cable, and tighten the screw.

Figure 8-53 Inserting the Transceiver Tap Frame and Coaxial Cable

④ With a drill, make a conductor probe hole in a coaxial cable to the extent that a white
insulation is visible. If the cap screw is heated, the aluminum tape may remain.
Remove shield cuttings from the hole section.

Figure 8-54 Drilling a Conductor Probe Hole in a Coaxial Cable

8-54