Sending Setups - Hitachi S10mini User Manual

5 USER GUIDE
(3) The [Save As] window is displayed. Enter the file name.
If a comment is required, enter it in the file comment field.
(Maximum number of input characters: 128 characters)
To change the PCs number, enter it in the PCs number field. (Maximum number of input
characters: 4-digit number)
(4) After completing the setup, click the
button.
The areas to be saved are self-node setup, PCs allocation of all nodes, IP address, and
subnet mask. The operation function is not saved. To save it, use the ladder diagram
system or batch save/load system.

5.6.9 Sending setups

Function: Load the self-node setup, PCs allocation of all nodes, and IP address and subnet mask of
the FL.NET module, which were saves on the PC by the saving function, onto the PCs.
For using this function, it is a prerequisite that the PCs is connected to the PC by cable.
Operation: The procedure is shown below.
(1) Select [Main] or [Sub] from the [Module] menu of the [FL.NET] window or [[S10V] FL.NET]
window.
Save button. To cancel the setup, click the
5-144
Cancel