Hitachi S10mini User Manual page 99

The table below shows the acceptable input ranges for various input items.
Input item
Area 1 address
Area 1 word count
Area 2 address
Area 2 word count
Note 1: The area selected for reception setup for an other (remote) node must not be a duplicate
of the area allocated in the self-node CPU or LPU memory area.
Note 2: CPU or LPU memory N allocation cannot be performed over more than one PI/O range.
Example: An unacceptable setup example is given below:
If the CPU or LPU memory area word count differs from the common memory
size setting (link parameter area word count), the FL.NET module transfers
data from the common memory. The amount of this data transfer is
determined from the number of words specified by the CPU or LPU memory
area word count setting.
If any node is left without being set, the FL.NET module cannot transfer to the
S10mini or S10V the data received from that node into the common memory.
Description
Specify the starting address of the area 1
reception area for the specified node
(having the node number indicated at the
left end).
Specify the size of the area 1 reception
area for the specified node (having the
node number indicated at the left end).
Enter a hexadecimal number.
Specify the starting address of the area 2
reception area for the specified node
(having the node number indicated at the
left end).
Specify the size of the area 2 reception
area for the specified node (having the
node number indicated at the left end).
Enter a hexadecimal number.
When the word count (size) setting for area 1 is 3, "RWFF0" cannot be
specified as the area 1 address (because the RW area limit would be
exceeded).
Acceptable selection range
See Table 5-7, "Address Ranges for
Common Memory Area Allocation in CPU
or LPU Memory."
0 to 0x200 (512)
See Table 5-7, "Address Ranges for
Common Memory Area Allocation in CPU
or LPU Memory."
0 to 0x2000 (8192)
5-47
5 USER GUIDE