Figure 4-2 Connecting The 10Base-T Cable To The Module - Hitachi S10mini User Manual

When the 10BASE5 connector is connected, make sure that the lock post is
locked by the retainer. If the lock post is not properly locked, a malfunction
may be caused by a poor contact or open circuit.
Do not touch the 10BASE5 connector while the power supply is ON. Failure
to observe this precaution may cause the system to malfunction due to static
electricity.
(2) Connecting the 10BASE-T cable
When the module number selector switch is set to 2 or 3, the module uses the 10BASE-T
interface connector to establish communication with the other modules.
Ensure that the 10BASE-T cable is connected as shown in Figure 4-2.
LQE502 for
LQE502

Figure 4-2 Connecting the 10BASE-T Cable to the Module

4 FL.NET MODULE WIRING PROCEDURES
LQE500 FL.NET
TX
MODU
RX
No.
LER
10BASE
-5
10BASE
-T
12V
GND
FG
4-3
Connect the cable to the
10BASE-T interface connector.
10BASE-T interface cable