ABB ACH580 Series Installation, Operation And Maintenance Manual page 119

ACH580 Ultra-Low Harmonic Drives Installation, Operation and Maintenance Manual
Error messages
#
1
2
3
4
5
6
7
8
9
10
Maintenance
See Maintenance
Error Message
CAN'T EDIT
PAR IS READ ONLY
CAN'T EDIT
WHEN STARTED
CAN'T EDIT
UP+DOWN ONLY
CAN'T EDIT
INP VOLTAGE LOW
CAN'T EDIT
PAR IS HIDDEN
CAN'T EDIT
UNDER LO-LIMIT
CAN'T EDIT
UNDER HI-LIMIT
CAN'T EDIT
ENUM VAL ONLY
CAN'T EDIT
NO DEFAULT
CAN'T EDIT
TRY AGAIN.
for the ACH580-31 on page
Description
Try to save value (=press the ENTER key in Parameter Edit
State) of a read-only parameter. E.g. try to change value
PAR 01.02 INPUT VOLT
Try to change value of a parameter, which is allowed to be
changed only when system is not started. E.g. PAR 16.02
PERMISSIVE
Try to change value of a "reset only" parameter other than
zero. UP+DOWN buttons must be pressed simultaneously
for requesting default value of the PAR on the display
(value zero), and after that ENTER pressed for saving it
(reset the parameter). E.g. PAR 04.01 LAST FAULT
Input voltage too low. Changing of parameters prohibited
since system cannot save values to nv-mem w/ insufficient
voltage.
Try to save value (=press the ENTER key in Parameter Edit
State) of a hidden parameter. Should not be possible. If
hidden parameters are turned visible, this message is not
given.
Try to save value which is over LO-LIMIT of the parameter.
Should not be possible when changing parameters from
control panel.
Try to save value which is over HI-LIMIT of the parameter.
Should not be possible when changing parameters from
control panel.
Try to save value which is out of enumerated value list.
Should not be possible when changing parameters from
control panel.
Try to request default value (=press UP and DOWN buttons
simultaneously) for a parameter which is defined not to
have a default value. Should not be possible when
changing parameters from control panel.
Parameter system is busy, e.g. application macro change is
in process at the same time when someone is trying to save
a value for a parameter. Should not be possible when
changing parameters from control panel.
74 and PCR, PDR on page 125.
119
ACH580-3BCR/BDR