ABB ACH580 Series Installation, Operation And Maintenance Manual page 91

ACH580 Ultra-Low Harmonic Drives Installation, Operation and Maintenance Manual
Digital I/O
control
terminals
J2
connection
GND J6
BYPASS CONTROL
ESC ENTER
ENABLED
HAND
SELECTED
FAULTED
DRIVE BYPASS
OFF/RESET
AUTO
MOTOR RUN
EIA-485
port
control
terminals
J7
connection
Bottom view
J8
connection
Basic connections
The figure on page 94
control connections for use with the
E-Clipse Bypass HVAC Default macro.
These connections are described in the
following paragraphs.
In typical installations, only analog input
wires connect to the ACH580 terminal
block, with other control connections
made on the E-Clipse Bypass control
board.
Use wire ties to permanently affix control/
communications wiring to the hooked wire
race tie points provided, maintaining a
minimum 6 mm (1/4 in.) spacing from
power wiring.
Drive's power connection terminals
The following tables list the maximum
power and motor cable terminal sizes for
connections to an input circuit breaker or
disconnect switch, a motor terminal block
and ground lugs. The tables also list
that should be applied when tightening the
terminals.
91
shows the basic
torque
ACH580-3BCR/BDR