ABB ACH580 Series Installation, Operation And Maintenance Manual page 8

8
ACH580 Ultra-Low Harmonic Drives Installation
Installation
Study these installation instructions carefully before proceeding. Failure to observe
the warnings and instructions may cause a malfunction or personal hazard.
WARNING! Before you begin read
1. Check mounting surface and free space requirements
The drive must be installed on a vertical wall or surface. The surface construction or
support structure must be sufficient to support the weight of the connected drive(s).
Follow IBC and any local code requirements for the correct mounting and fastening
requirements. The mounting surface must be free from vibration and not exceed the
vibration specifications defined in the ACH580-31 Hardware manual, Technical data
section for Vibration (IEC 60068-2). Three acceptable mounting orientation include:
• vertically alone
• vertically side by side
• horizontally alone
Note: UL Type 1 (IP21) only meets UL "Open" type in horizontal orientation
Note: Do not install upside down.
Check that adequate clearance exists between the drive and other surfaces
including other drives.
ACH580 Ultra-Low Harmonic Drives Installation
ACH580 Ultra-Low Harmonic Drives Installation, Operation and Maintenance Manual
Safety instructions on page 3.