Huawei FusionModule2000 Product Description page 136

FusionModule2000 Smart Modular Data Center
Product Description (380 V)
Item
Indicators
Table 3-97 describes the indicators on the AC actuator.
Table 3-97 AC actuator indicators
Indicat
or
Power
RUN
ALM
RF_Z
Issue 04 (2017-06-30)
Specifications
networking.

Hold down the button for more than 6 seconds to clear network
parameters.
Col Name
or
Gree Power status
n indicator
Gree Running status
n indicator
Red Alarm indicator
Gree Communication
n status indicator
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Status Description
Steady on The power input is normal.
Off There is no power input.
Off The power is abnormal or the board
program is loading.
Blinking at The AC actuator successfully
long intervals registers with the ECC800 and the
software runs properly (the
indicator blinks at 0.5 Hz, on for 1s
and then off for 1s).
Blinking at The communication is disconnected
short intervals or the AC actuator fails to register
with the ECC800 (the indicator
blinks at 4 Hz, on for 0.125s and
then off for 0.125s).
Blinking The indicator blinks at super short
intervals for 0.5s (blinking at 10 Hz,
on for 0.05s and then off for 0.05s)
and then turns off for 0.5s. The
cycle lasts for 10s.
Steady on A system failure alarm is generated.
Off No system alarm is generated.
Steady on No network parameters exist, or a
network is to be created.
Blinking at A network is set up, and no node
long intervals access is allowed (the indicator
blinks at 0.5 Hz, on for 1s and then
off for 1s).
Blinking at A network is set up, and node
super short access is allowed (the indicator
intervals blinks at 10 Hz, on for 0.05s and
3 System Architecture
129