Yamaha QY700 Owner's Manual page 157

7. Song Jobs
1. Source track
• The first TR setting selects the track from which events are
to be extracted.
01,...,32
0101
1101
2. Source segment
• The two boxes to the right of the M select the track segment
for the extraction.
001:1,...,999:8
Measure: beat
0101
1101
3. Spot clock
• The Spot Clock parameter selects the interval of each meas-
ure from which data are to be extracted.
• The interval is set by clock cycles, where each measure starts
at cycle 0000. There are 480 cycles per quarter note.
• For example, assume that timing is set to 4/4. In this
case, if you want to extract data only from the first half
of each measure, you would set the range to 0000 – 0959.
If you wanted to copy only those events that fall exactly
on the fourth beat, you would set the range to 1440 –
1440.
0000 0480
4/4
0000 0240 0480 0720
6/8
0000,...,3840
0101
1101
4. Destination track
• The lower TR setting selects the destination track.
01,...,32, Off
0101
1101
• 01,...,32
Sequence track
• Off
No destination. (Extract and delete)
156
0960 1440 1919
0960 1200 1439
Chapter 2. SONG MODE
5. Event
• The third pair of boxes (at the center of the screen) select
the event type to be extracted.
Note, PC, PB, CC (000,...,127, All), CAT, PAT, EXC
0101
1101
• Note
• PC
• PB
• CC(000,...,127,All) Control change (Any single control-
• CAT
• PAT
• EXC
6. Argument range
• The lowest two boxes on the screen select the argument
range. The QY700 will extract only those note events whose
arguments fall within the specified range.
• If you are extracting note events, for example, you can use
this setting to limit extraction to all note events within a
certain pitch range (for example, C3 to C4). If extracting
program-change events, you can limit extraction to events
with a certain range of program numbers only.
• Note that the EXC event type does not accept an argument-
range value.
• The values listed below show the maximum ranges. In all
cases you can set a smaller range. Note that the first value
of the range must be less than or equal to the second value.
C-2,...,G8
Maximum range for note events
0101
1101
-8192,...,+8191 Maximum range for pitchbend events
000,..,127
Maximum range for all event types other than
note and pitchbend.
Note events (C2,...,G8, All)
Program change
Pitch bend
change message type 000 to 127, or
all control-change messages)
Channel aftertouch
Polyphonic aftertouch
System exclusive