Yamaha QY700 Owner's Manual page 268

Job 10 Shift Event
• This job replaces all occurrences of a specified event type
(within the selected segment of the selected phrase) with
some other designated event type. Although the event type
itself is replaced, its accompanying argument (parameter
value) is retained and applied to the new event type.
• As an example, you can use this function to change every
breath-controller event into a channel-aftertouch event, while
leaving the magnitude of the event unchanged.
1. Phrase
• The Phrase value selects the user phrase.
01,...,99
0101
1101
2. Segment
• The two boxes to the right of the M select the phrase seg-
ment over which the substitutions are executed.
001:1,...,256:8
Measure:beat
0101
1101
3. Source event
• The two boxes at the center select the event type to be re-
placed.
CC 001,...,031,033,...,127 Control-change event
0101
1101
CAT
PB MSB
Note
Note (Velo=64)
Note
Velo# (Note=C3)
Channel aftertouch
Pitch bend MSB
Note event (where the note-
number argument is re-
tained.)
Note event (where the ve-
locity argument is retained.)
Chapter 5. PATTERN MODE
4. Destination event
• The two boxes at the bottom select the event type that re-
places the "source" event.
CC 001,...,031,033,...,127 Control-change event
0101
1101
CAT
PB MSB
Note
Note (Velo=64)
Note
Velo# (Note=C3)
7. Pattern Jobs
Channel aftertouch
Pitch bend (With the LSB
argument set to 00.)
Note event (where original
5
argument gives the new note
number; velocity is set to 64;
and gate time is set to 108.)
Note event (where original
argument gives the new ve-
locity; the new note becomes
C3; and gate time is set to
108.)
267