Voice Program; Play-Effects Thru Setting - Yamaha QY700 Owner's Manual

• Press or
number for the desired track is highlighted.
• Note that the screen only shows tracks 1 to 16 or tracks
17 to 32. You can toggle between these two groupings
by pressing .
2. Measure and beat
• The measure value sets the start point for song playback.
• The measure and beat values increase during playback, in-
dicating the current song location.
001,...,999
Measure:
0101
1101
1. Press [D1] to move the cursor to the measure
display area.
2. Set the measure value using the data dial,
the numeric keypad
• You can change the measure value while song playback is
in progress. Playback will immediately jump to the new
location.
• There are three ways to change the measure during play-
back, as follows.
• Press [D1] to move the cursor to the measure
display area, and then change the value as described
above.
• Rotate the shuttle dial, or press
• Press to return to the top of the song (measure 001,
beat 1).
• When you select a new song, the measure value automati-
cally switches to 001.
until the track
/ , or
.
or .
Chapter 2. SONG MODE

3. Voice program

• The icons indicate the voice program assigned to each track.
• You select the voices using VOICE mode. (

4. Play-effects THRU setting

• You use this setting to determine whether or not to apply
the play effects to the corresponding track. If you set the
value to , the QY700 will play the track without using
the play effects.
• The QY700 memorizes the THRU settings separately for
each song
Apply play effects to the track.
0101
1101
Do not apply play effects to the track.
1. Move the cursor to the P.FX.THRU line for the track
you want to set.
2. Change the setting using the data dial or the
key.
2. Play Effects
2
p.168)
or
85