Yamaha QY700 Owner's Manual page 49

BASIC CONCEPTS
Chorus effect
• The chorus effect is dedicated to chorus. It adds spacious-
ness and depth to the sound.
• In Effect mode, you can select one of 11 Effect Types, and
modify parameter values to adjust the character of the cho-
rus. Effect mode settings are remembered independently for
each song.
• In Pattern mode, you can use Pattern Effect settings to se-
lect one of 11 Effect Types for each pattern, and modify
parameter values to adjust the character of the chorus.
Variation effect
• The variation effect provides 43 types of effect including
reverb and chorus, and also distortion and overdrive etc.
• In Effect mode, you can select one of 43 Effect Types, and
modify parameter values to adjust the character of the ef-
fect. Effect mode settings are remembered independently
for each song.
• In Pattern mode, you can use Pattern Effect settings to se-
lect one of 43 Effect Types for each pattern, and modify
parameter values to adjust the character of the effect.
System Effects and Insertion Effects
• The effects of the effect block are divided into two types of
effect which function in completely different ways: system
effects and insertion effects.
• On the QY700, the reverb effect and the chorus effect are
system effects, and the variation effect can be set either as a
system effect or an insertion effect.
• In the case of a system effect, effect processing is performed
by using the mixer Send and Return controls to send sig-
nals from each tone generator Part to the effect and then
return the processed signal to the mixer.
• In the case of an insertion effect, the effect is connected in
series between the instrument and the mixer, and adjusted
using the Dry/Wet Balance. On the QY700, an insertion
effect can be used on any one specified Part.
• System effects and insertion effects are defined within "XG."
This means that if you use a tone generator bearing the XG
logo, you can use effects not only in a "minimal" way by
simply applying chorus and reverb, but also in a more ag-
gressive way to create the fundamental character of the
sounds.
Insertion effect
48
How the effects work
Variation mode = Insertion
• When Variation mode is set to Insertion, the three effects
• Of the 32 parts of the tone generator block, the signals of
• The signals of all tone generator parts including the above-
• To adjust the overall depth of each effect, use the Effect
• The stereo location of the effect output is determined by the
• A bus line called Send Chorus To Reverb 8 connects the
System effects
Chapter 1
will be connected as shown in the diagram below.
the part specified by the Voice mode Variation Switch 1
will be input to the variation effect, and the variation effect
will be applied here.
mentioned part will be sent to the reverb effect and the cho-
rus effect according to the Voice mode settings Reverb Send
Level 2 and Chorus Send Level 3. Here you can adjust
the depth of the effect for each part.
mode settings Reverb Return Level 4 and Chorus Return
Level 5. Here you can adjust the amount of the signal re-
turned from each effect, determining the overall depth of
each effect.
Effect mode settings Reverb Pan 6 and Chorus Pan 7.
chorus effect to the reverb effect. By using this bus line you
can connect the chorus effect and reverb effect in series.