Yamaha QY700 Owner's Manual page 291

1. System
3. Footswitch
• This sets the function of the footswitch connected to the
rear panel FOOT SW connector.
Start/Stop, Section, Sustain, Sostenuto
0101
1101
Start/Stop
Each time the footswitch is pressed, the song
or pattern will alternately start or stop.
Section
Each time the footswitch is pressed, the Sec-
tion of the pattern will be switched in the or-
der of A – H.
Sustain
All notes played while the footswitch is held
will be sustained until the footswitch is re-
leased.
Sostenuto
All notes which were being held on the key-
board when the footswitch was pressed will
be sustained until the footswitch is released.
4. Pitch bend wheel, Assignable wheel
• These settings specify the MIDI messages that are output
when the PITCH wheel and ASSIGNABLE wheel located
on the QY700's top panel are operated.
• Since the PITCH wheel will automatically return to the
center position when it is released, it is suitable for control-
ling Pitch Bend.
• The ASSIGNABLE wheel is detented in the center posi-
tion.
OFF, P.B., Ctrl#001 – 119, CAT, VEL, TMP
0101
1101
OFF
The wheel will have no function.
P.B. (Pitch Bend)
Pitch Bend messages.
Ctrl#001 (Modulation) – 119 (ContrlChng)
Control Change messages. You can choose the control
number. However, Ctrl#032 cannot be selected.
CAT (Ch After)
Channel aftertouch messages
VEL (Velocity)
Velocity
TMP (Tempo)
Tempo
290 Chapter 6. UTILITY MODE