Sequencer - Yamaha QY700 Owner's Manual

4. Sequencer

F1 F2
• Here are the setup parameters for the sequencer block.
1. Press .
The indicator located above
will enter Utility mode.
2. Press (Seqencr) to access the Sequencer page.
3. Move the cursor to the parameter that you wish to set.
4. Use / , the data dial, or numeric keypad
to set the value.
1. Mute tracks level
• This setting specifies how much the volume (velocity) will
be reduced when a track is muted.
• This setting will also affect the other tracks that are muted
when a track is soloed.
Off, 01% – 99%
0101
1101
Off
There will be no sound.
01% – 99%
The velocity values will be reduced by the
specified percentage.
The muted volume will be (original veloc-
ity) x (mute track setting).
F3 F4 F5 F6
will light, and you
Chapter 6. UTILITY MODE
2. Event chase
• Event Chase is a function that rapidly plays back the speci-
fied types of event when a song, pattern, or phrase is played
back from the middle or when it is rewound or fast-for-
warded. This ensures that voice selections and pitch changes
etc. will be correct for the location when playback begins.
• If a song or phrase which uses program changes or pitch
bend changes is played back from the middle or is rewound
or fast-forwarded, the playback may use unexpected voices
or the wrong pitch. Such problems can occur if the section
of the song or phrase that was skipped over contains events
such as program changes or pitch bends.
• If the Event Chase function is used, the specified type(s) of
event will be played back at high speed from the beginning
whenever a song or phrase is played back from the middle.
This will mean that a certain length of time may elapse from
the moment the Start command is given until playback ac-
tually begins, or that the rewind/fast-forward speed will be
slower.
• If Event Chase is set to ALL, large amounts of MIDI data
will be transmitted from the MIDI OUT connector, which
can cause MIDI errors to occur on the external MIDI de-
vice that is receiving this data.
Off, PC, PC,PB,Ctrl, ALL
0101
1101
Off
Event Chase will not be performed.
PC
Program Change messages
PC,PB,Ctrl
Program Change, Pitch Bend, and Control
Change messages
ALL
All events other than notes
4. Sequencer
System
MIDI
MIDI filter
Sequencer
Click
Fingered chord zone
6
295