Yamaha QY700 Owner's Manual page 181

3. Voice edit
Volume
portion that is
passed
Overtones
• The filter resonance can be specified for each part to modify
the sound.
• Resonance boosts the volume in the area of the cutoff fre-
quency, emphasizing the overtones in that area. By appro-
priate settings of Resonance, you can simulate the body reso-
nance of stringed instruments etc., or produce sounds typi-
cal of analog synthesizers.
Cutoff
-64–+00–+63
Filter Cutoff
0101
1101
-64–+00–+63
Filter Resonance
10. EG attack time,
EG decay time,
EG release time
• These parameters adjust the time-based changes that occur
between the moment that a note is played to when the sound
disappears.
• Attack Time adjusts the time over which the volume rises
from zero (when the note is played) to reach the maximum
level.
Smaller values will produce a faster attack.
• Decay Time adjusts the time over which the volume falls
from the maximum to reach the sustain level.
Smaller values will produce a more sharply defined sound.
180
portion that is cut
Frequency
Cutoff frequency
Resonance
Frequency
Chapter 3. VOICE MODE
• Release Time adjusts the time over which the volume falls
from the sustain level (when the note is released) to reach a
level of 0.
Smaller values will cause the sound to reach silence more
quickly.
Attack Time
-64–+00–+63
• EG Attack Time
0101
1101
-64–+00–+63
• EG Decay Time
• EG Release Time -64–+00–+63
11. Vibrato rate, Vibrato depth, Vibrato delay
• These parameters are the vibrato settings.
• Rate adjusts the speed at which pitch is modulated, Depth
adjust the depth of modulation, and Delay adjusts the time
from when the note is played until vibrato begins to occur.
Delay
Rate
-64–+00–+63
Rate
0101
1101
-64–+00–+63
Depth
-64–+00–+63
Delay
Release Time
Decay Time
Depth