Siemens SINUMERIK 840D sl Programming Manual page 296

Tool radius compensation
10.3 Compensation at the outside corners (G450, G451, DISC)
Program code
N90 G0 Y100
N100 X200 M30
Further information
G450/G451
At intermediate point P*, the control executes operations such as infeed movements or
switching functions. These operations are programmed in blocks inserted between the two
blocks forming the corner.
With G450 the transition circle belongs to the next travel command with respect to the data.
DISC
When DISC values greater than 0 are specified, intermediate circles are shown with a
magnified height – the result is transition ellipses or parabolas or hyperbolas:
An upper limit can be defined in machine data – generally DISC=50.
296
Comment
Programming Manual, 09/2011, 6FC5398-1BP40-2BA0
Fundamentals