Geometry settings
8.3 Dimensions
8.3.6
Channel-specific diameter/radius programming (DIAMON, DIAM90, DIAMOF,
DIAMCYCOF)
Function
During turning, the dimensions for the transverse axis can be specified in the diameter (
or in the radius (
So that the dimensions from a technical drawing can be transferred directly (without
conversion) to the NC program, channel-specific diameter or radius programming is activated
using the modal commands DIAMON, DIAM90, DIAMOF, and DIAMCYCOF.
Note
The channel-specific diameter/radius programming refers to the geometry axis defined as
transverse axis via MD20100 $MC_DIAMETER_AX_DEF ( → see machine manufacturer's
specifications).
Only one transverse axis per channel can be defined via MD20100.
Syntax
DIAMON
DIAM90
DIAMOF
180
②
):
Programming Manual, 09/2011, 6FC5398-1BP40-2BA0
①
)
Fundamentals