Siemens SINUMERIK 840D sl Programming Manual page 539

TRACON INT: Number of
the trans-
formation
TRAFOOF
For each transformation type, there is one command for one transformation per channel. If
there are several transformations of the same transformation type per channel, the
transformation can be selected with the corresponding command and parameters. It is
possible to deselect the transformation by a transformation change or an explicit deselection.
8. Spindles
Keyword / 1st parameter
subroutine
identifier
SPCON INT: Spindle
number
SPCOF INT: Spindle
number
SETMS INT: Spindle
number
9. Grinding
Keyword / 1st parameter
subroutine
identifier
GWPSON INT: Spindle
number
GWPSOF INT: Spindle
number
TMON INT: Spindle
number
TMOF INT: T number
Fundamentals
Programming Manual, 09/2011, 6FC5398-1BP40-2BA0
REAL: Further Transformation concentrated: Cascaded transformation; the
parameters, meaning of the parameters depends on the type of cascading.
MD-dependent
Deactivate transformation
2nd parameter Explanation
and others
INT: Spindle Spindle position control ON: Switch to position-controlled spindle
number operation.
INT: Spindle Spindle position control OFF: Switch to speed-controlled spindle
number operation.
Set master spindle: Declaration of spindle as master spindle for
current channel.
With SETMS( ), the machine-data default applies automatically
without any need for parameterization.
Explanation
Grinding wheel peripheral speed ON: Constant grinding wheel peripheral speed ON.
If the spindle number is not programmed, then grinding wheel peripheral speed is
selected for the spindle of the active tool.
Grinding wheel peripheral speed OFF. Constant grinding wheel peripheral speed OFF.
If the spindle number is not programmed, grinding wheel peripheral speed is
deselected for the spindle of the active tool.
Tool monitoring ON:
If no T number is programmed, monitoring is activated for the active tool.
Tool monitoring OFF:
If no T number is programmed, monitoring is deactivated for the active tool.
16.5 Predefined subroutine calls
Tables
539