(1) Connection to user program development environment, Personal computer for
maintenance, and superior control servers, etc.
The following personal computer can be connected using the user Ethernet port (CH1 and CH2)/built-in Ethernet
port (CH1 and CH2).
• User program development environment (CW Workbench and Wind River Workbench)
• Personal computer for maintenance (Telnet and FTP functions)
• Host communication network's superior control servers (MES server and SNTP server, etc.)
For wiring of the Ethernet cable, refer to the following.
Page 127, Section 8.7.2
Remark
● For the functions of user Ethernet port/built-in Ethernet port, refer to the following.
Page 192, Section 12.1
(2) Connection to Personal computer with Setting/monitoring tools for the C
Controller module installed
The following illustrates a sample case of connection with Setting/monitoring tools for the C Controller module.
For versions of Setting/monitoring tools for the C Controller module, refer to the following.
Page 52, CHAPTER 4
(a) Connection via USB connector
Use the USB connector for connection.
*1 :
Use USB2 for Q24DHCCPU-V/-VG/-LS and Q26DHCCPU-LS.
For specifications and wiring of the USB cable, refer to the following.
Page 125, Section 8.7.1
Connection to USB connector is only possible from 1 Personal computer to 1 C Controller module.
112
Q24DHCCPU-V/-VG/-LS
Q26DHCCPU-LS
*1
Q24DHCCPU-V/-VG/-LS
Q26DHCCPU-LS
For "-LS", consult with the
partner (operating system vendor).
Q12DCCPU-V
Q12DCCPU-V