Mitsubishi Electric MELSEC Q Series User Manual page 438

Event No. Event type
C000021C System (Err.)
H
C000021D System (Err.)
H
C0000300 System (Warning)
H
(2) Actions against each event No. that occurs in "MXwdkDrv"
Actions against each event No. that occurs in "MXwdkDrv" are described below.
Event No. Event type
40000000 System (Info.)
H
40000002 System(info.)
H
40000003 System(info.)
H
80000004 System (Warning)
H
C0000001 System (Err.)
H
C0001001 System (Err.)
H
*1 : Not supported by Q24DHCCPU-LS and Q26DHCCPU-LS.
(3) Actions against each event No. that occurs in "MUtlIFQbf / MUtlIFMd / MUtlIFCom"
Actions against each event No. that occurs in "MUtlIFQbf / MUtlIFMd / MUtlIFCom" are described below
Event No. Event type
C0000000 System (Err.)
H
C0000001 System (Err.)
H
C0000002 System (Err.)
H
C0000003 System (Err.)
H
C0000004 System (Err.)
H
436
Event
CPU LAY ERROR occurred.
DUPLICAT.NET.NO. occurred.
Initialization of Ethernet port for MELSOFT connection failed.
Event
The clock data of the C Controller module have been set.
This event occurs when:
• Clock data was set by the user program.
• Clock data was set by Setting/monitoring tools for the C Controller
module.
• Clock data was set by peripheral devices such as GOT.
The clock data were corrected by the clock synchronization function.
This event is registered when a clock data difference from a CPU No.
1 is detected after enabling the Clock synchronization function.
The clock data were corrected by the time setting function (SNTP
function).
The event history information was initialized because an error was
detected in the event history information.
An exceptional error occurred.
Event
An illegal packet error occurred.
An instruction error occurred.
A socket generation error occurred.
A port acquisition error occurred.
A bind error occurred.
Take corrective actions for error code 7036.
Take corrective actions for error code 3150.
Replace the C controller module.
*1
• Reexamine the user program by checking the event detail
information (such as error details, task names, and program
counters).
• Check the operation methods of CW Workbench.
• Replace the C controller module.
• Check the port number.
• Change the IP address.
Check the version of the utility and C Controller module.
• Restart the C Controller module.
• Please consult your local Mitsubishi service center or
representative, explaining the details of the problem.
Corrective action
Corrective action
-
*1
Corrective action
*1