Mitsubishi Electric MELSEC Q Series User Manual page 123

(2) Removal procedure
● During access to an SD memory card, do not perform the following operations:
• Unmounting SD memory card
• Removing SD memory card
● You may also unmount the SD memory card from the user program by using the CCPU_UnmountMemoryCard.
CHAPTER 8 INSTALLATION AND WIRING
1.
Pull the section labeled as "PULL" on the cover to
open the cover.
Open both right and left covers.
2.
Move the RESET/SELECT switch to the SELECT
position.
Do not release the switch while pulling it down.
3.
Check that the SD CARD LED start flashing.
4.
Move the RESET/SELECT switch back to the center.
Release the switch then it returns to its center position.
5.
Check that the SD CARD LED goes off.
6.
Press the SD memory card into the SD memory card
slot until it clicks and then pull it out straight.
7.
Close the C Controller module front cover until it
clicks.
8
121