Mitsubishi Electric MELSEC Q Series User Manual page 191

(2) Resolution setting
Execute one of the commands below with "STARTUP.CMD" or the Telnet connection to switch the screen display.
The changed setting will be enabled at the time of next startup of the display application.
For more information on the supported resolution, refer to the following section.
Page 45, Section 3.2
(a) Changing the resolution
• VGA
CCPUCMD_ChangeVGA
• SVGA
CCPUCMD_ChangeSVGA
• XGA
CCPUCMD_ChangeXGA
(b) Checking the resolution
Execute the following command with the Telnet connection to check the resolution
currently set.
CCPUCMD_GetResolution
(3) Precautions
(a) If the analog RGB cable is connected with the power supply for C Controller module
turned ON, the display will not be recognized.
*1
(b) GENWARE3-VG
functions of GENWARE3-VG, consult the partner (application vendor).
*1 : It is pre-installed in Q24DHCCPU-VG.
(c) When the battery less drive is enabled, the resolution setting is initialized at power-
on. For details on the battery less drive, refer to the following section.
Page 190, Section 11.11
is required in order to use this function. For specifications and
CHAPTER 11 BASIC FUNCTIONS
189
11