Transferring Device Data From The Pc To The Device - Siemens SIPROTEC 5 Manual

6.4

Transferring Device Data from the PC to the Device

NOTE
i
i
If the protection devices are connected to the engineering PC, the transfer of device data to one or more
devices is possible. For this purpose, you must initialize the devices once with DIGSI 5.
If you would like to transfer device data from the PC to the device, then connect the device to the PC. You can
use the following terminals for this purpose:
•
USB port on the on-site operation panel of the base module
•
Any Ethernet interfaces of the device
Check whether there is a connection between your DIGSI 5 project and your device.
²
Compare the serial number in the editor and the device information to the label of the device.
²
To do this, double-click in the project tree the Device information menu item under the device. You will
²
find the serial number in the General section.
Establishing a Connection Via USB
Connect the top USB port on the front panel of the on-site operation panel of the base module of
²
SIPROTEC 5 devices to the engineering PC using a suitable USB cable.
In the project tree of your DIGSI 5 project, double-click the Load configuration to the device menu item
²
in the corresponding offline configuration of the device.
Enter the confirmation ID for the user.
²
DIGSI 5 recognizes automatically that the device is connected via USB and the loading of configuration from
the DIGSI 5 project to the device is initiated.
Establishing a Connection Via Ethernet
[scipadrs-080413-01.tif, 1, en_US]
Figure 6-2
Connect, for example, the Ethernet port J on the rear of the SIPROTEC 5 base module to the engineering
²
PC using a suitable Ethernet cable.
In the project tree of your DIGSI 5 project, double-click the Devices and networks menu item.
²
In the network view, you will find all devices of your project with the offline configurations. Select the
²
device with which you would like to connect and click the green-edged field of the displayed device (see
Figure 6-2).
Enter the IP address, subnet mask and optionally the IP address of a router (standard gateway).
²
In the project tree of your DIGSI 5 project, double-click the Load configuration in devices menu item.
²
Execute this in the corresponding offline configuration of the device.
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-C, Edition 08.2020
Setting the IP address
6.4 Transferring Device Data from the PC to the Device
Using DIGSI 5
103