Activating The Battery - Siemens SIPROTEC 5 Manual

Produce the holes in the mounting wall to fit the device. The drill holes must be so large that they can
²
accept a screw with a shank diameter of 6 mm.
Produce the holes in the mounting wall to fit the on-site operation panel.
²
Cut a recess into the mounting wall for the connecting cable. The connecting cable links the on-site oper-
²
ation panels to the device.
Place a metallic layer such as a sheet metal panel on the mounting wall if it is not metallic.
²
Fitting the Device
First bolt the bottom fastening screws into the mounting wall.
²
Hook the bottom mounting bracket onto the bottom fastening screws.
²
Align the device in the oblong holes.
²
Screw the device onto the top mounting bracket with the fastening screws.
²
Check for secure attachment of the device on the mounting wall.
²
Installing On-Site Operation Panels
NOTE
i
i
Join several on-site operation panels to one another with firm contact. Siemens recommends the use of
contact washers on painted metal mounting walls. If the mounting wall is not metallic, place a metal layer,
for example a sheet metal panel, between the mounting wall and the on-site operation panel; then
connect this sheet to system ground.
Plug the connecting cable into the on-site operation panel of the base module.
²
Guide the connecting cable through the cut-out in the mounting wall.
²
Place the 2 contact washers on the top fastening holes.
²
Bolt down the on-site operation panels connected to one another on the mounting wall.
²
Check for secure attachment of the on-site operation panels on the mounting wall.
²

Activating the Battery

3.3.2
Removing the Protective Film
NOTE
i
i
The battery is covered with a protective film to protect it from mechanical damage and against premature
discharge.
The battery need not be removed from the battery compartment for activation.
Pull out the battery compartment.
²
Remove the protective film from the battery by simply pulling on the film tab.
²
Push the battery compartment back in again.
²
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-C, Edition 08.2020
3.3 Surface-Mounted Devices with Detached On-Site Operation Panel
Fitting the Devices
65