Siemens SIPROTEC 5 Manual page 150

Operation in the Operating State
8.4 Indications
Indications in
Log for parameter changes
Spontaneous indication window
(DIGSI 5)
Log for safety indications
Log for device-diagnostic indica-
tions 1
Log for communication indications
Log for communication supervision
(GOOSE)
Overview of Displayed Quality Attributes
If values are shown on the device display or in DIGSI, the following quality attributes are different for meas-
ured values and metered values.
Table 8-2
IEC 61850
Detail Quality
–
Failure
1 Only online access
150
DIGSI 5 Information
Time stamp (date and time),
Relative time,
Entry number,
Function structure,
Name,
Value,
Quality,
Cause,
Number
Time stamp (date and time),
Relative time,
Indication,
Value,
Quality,
Additional Information
Time stamp (date and time),
1
Indication number,
Indication
Time stamp (date and time),
Indication number,
Indication
Time stamp (date and time),
1
Indication number,
Indication
Time stamp (date and time),
Relative time,
Entry number,
Function structure,
Name,
Value,
Quality,
Cause,
Number
Measured Values
Validity
Good Invalid Questionable
X
X
Device Display Information
Time stamp (date and time),
Function structure,
Name,
Value
Time stamp (date and time),
Fault number,
Value
Time stamp (date and time),
Indication
Time stamp (date and time),
Indication
Time stamp (date and time),
Indication
Time stamp (date and time),
Function structure,
Name,
Value
Device Display/ Description
DIGSI
Value The measured value is valid.
Fault The device is defective. Contact
Support.
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-C, Edition 08.2020