Siemens SIPROTEC 5 Manual page 258

Maintenance, On-the-Spot Assistance and Test
10.5 Test and Diagnostics
[scblkdir-080413-01.tif, 1, en_US]
Figure 10-24
•
Activate block monitoring direction via a binary input.
•
Activate block monitoring direction via DIGSI 5.
[scmemspr-081015, 2, en_US]
Figure 10-25
When switching block monitoring direction on or off, an indication is output in the left area of the status bar.
Bar segments inform you as well about progress of the procedure.
NOTE
i
i
The settings via the on-site operation, like the binary inputs, have no effect for the DNP3 protocol.
The >Block monitoring dir. signal is supported by the IEC 60870-5-103 protocol only.
258
Block Monitoring Direction at the Device
Block Monitoring Direction via DIGSI 5
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-C, Edition 08.2020