Mount Indoor Unit - Beko BEHPI 090 Installation Manual

5 Indoor un t nstallat on
2. Us ng adhes ve v nyl tape, attach the dra n hose to the unders de of the refr gerant p pes.
3. Us ng nsulat on tape, wrap the s gnal w re, refr gerant p pes, and dra n hose t ghtly together.
Double-check that all tems are bundled n accordance w th F g. 5.10.
Do not wrap ends of p p ng
When wrapp ng the bundle, keep the ends of the p p ng unwrapped. You need to access them to test
for leaks at the end of the nstallat on process (refer to Electr cal Checks and Leak Checks sect on of
th s manual).
Step 8: Mount ndoor un t
If you nstalled new connect ve p p ng to the outdoor un t, do the follow ng:
1. If you have already passed the refr gerant p p ng through the hole n the wall, proceed to Step 4.
2. Otherw se, double-check that the ends of the refr gerant p pes are sealed to prevent d rt or fore gn
mater als from enter ng the p pes.
3. Slowly pass the wrapped bundle of refr gerant p pes, dra n hose, and s gnal w re through the hole n
the wall.
4. Hook the top of the ndoor un t on the upper hook of the mount ng plate.
5. Check that un t s hooked f rmly on mount ng by apply ng sl ght pressure to the left and r ght-hand
s des of the un t. The un t should not j ggle or sh ft.
6. Us ng even pressure, push down on the bottom half of the un t. Keep push ng down unt l the un t
snaps onto the hooks along the bottom of the mount ng plate.
7. Aga n, check that the un t s f rmly mounted by apply ng sl ght pressure to the left and the r ght-
hand s des of the un t.
If refr gerant p p ng s already embedded n the wall, do the follow ng:
1. Hook the top of the ndoor un t on the upper hook of the mount ng plate.
2. Use a bracket or wedge to prop up the un t, g v ng you enough room to connect the refr gerant
p p ng, s gnal cable, and dra n hose. Refer to F g. 5.11 for an example.
26 / 120 EN
Spl t-type room a r cond t oner / Installat on Manual