Indoor Unit Adjustment - Beko BEHPI 090 Installation Manual

5 Indoor un t nstallat on
3. Connect dra n hose and refr gerant p p ng (refer to Refr gerant P p ng Connect on sect on of th s
manual for nstruct ons).
4. Keep p pe connect on po nt exposed to perform the leak test (refer to Electr cal Checks and Leak
Checks sect on of th s manual).
5. After the leak test, wrap the connect on po nt w th nsulat on tape.
6. Remove the bracket or wedge that s propp ng up the un t.
7. Us ng even pressure, push down on the bottom half of the un t. Keep push ng down unt l the un t
snaps onto the hooks along the bottom of the mount ng plate.
Un t s adjustable
Keep n m nd that the hooks on the mount ng plate are smaller than the holes on the back of the un t.
If you f nd that you don't have ample room to connect embedded p pes to the ndoor un t, the un t can
be adjusted left or r ght by about 30-50mm (1.25-1.95 n), depend ng on the model. (See F g. 5.12)
30-50mm
(1.2-1.95 n)
Spl t-type room a r cond t oner / Installat on Manual
30°
F g. 5.11
Move to left or r ght
F g. 5.12
Wedge
30-50mm
(1.2-1.95 n)
27 / 120 EN