NEC Express5800/R320g-M4 Maintenance Manual page 110

Chapter 1 Maintenance
2. After making sure that periphery cables (except power calble) are removed, run EXPRESSBUILDER and
choose Tool menu from Boot Selection Menu.
For more information, see Chapter 3 (5. Details of EXPRESSBUILDER).
3. Choose Test and diagnostics. Shows the following three menus.
 End-User Mode (Basic)
Run basic System Diagnostics.
When this menu selected, the process start automatically. Then it takes about three minutes.
When the diagnostics is completed, the screen display changes as shown below.
 End-User Mode (Professional)
Run detail System Diagnostics.
When this menu selected, shows the screen of Device List(End-User Pro).
See eupro_ug_en.pdf in the \isolinux\diag folder of EXPRESSBUILDER for the End-User Mode
(Professional) feature.
After System Diagnostics are completed, perform Step 6 of this procedure.
 Supervisor-Mode
This menu is intended for maintenance personnel.
Do not run this menu.
End-User Mode (Basic) (After the System Diagnostics)
Diagnostics tool title
Guideline
Diagnostics tool title
Shows the name and version of the diagnostic tool.
Test window title
Shows the progress of the diagnostics. "Test End" is displayed when the diagnostics completes.
Test results
Shows the start, end, and elapsed time and completion status of the diagnostics.
Express5800/R310g-E4, R320g-E4, R320g-M4 Maintenance Guide (Windows)
110
Choose English if Language selection menu appears.
Note
11. System Diagnostics
Test window title
Test results
Test summary window