NEC Express5800/R320g-M4 Maintenance Manual page 55

Chapter 1 Maintenance
(7)
Management LAN
(1)
System POWER LED
LED indication
On (green)
Off
(2)
System FAULT LED
LED indication
Off
On (amber)
Blinking (amber)
(3)
System FT LED
LED indication
On (green)
Off
(4)
System ID LED
LED indication
On (blue)
Blinking (blue)
Off
Express5800/R310g-E4, R320g-E4, R320g-M4 Maintenance Guide (Windows)
Module ID LED
10G LAN connector
(R320g-M4 only)
connector
< Rear >
Description
Either or both of CPU/IO modules are powered on.
Both of CPU/IO modules are powered off.
Description
Both of CPU/IO modules are offline or normal.
One of the CPU/IO modules failed.
One of the CPU/IO modules failed.
Failed CPU/IO module cannot be identified.
Description
System is operating under duplex condition.
System is not duplexed.
Description
UID switch is pressed.
The server is receiving an identification request sent
by remote.
–
(9) Power Unit LED
1G LAN connector
SPEED LED
LINK/ACT LED
Action
–
–
Action
System FAULT LED does NOT notify of
disk statuses. Check it according to (5)
DISK ACCESS LED indication.
Take a note of LED indications on
EXPRESSSCOPE, and then contact
your sales representative.
Contact your sales representative.
Action
–
–
Action
–
–
–
6. Error Messages
55