NEC Express5800/R320g-M4 Maintenance Manual page 143

Chapter 2 Configuring and Upgrading the System
6. Click Additional properties.
Specify the required settings, and then click OK.
Teaming mode
Static Teaming
Switch Independent
LACP
Load balancing mode
Address Hash
Hyper-V Port
Dynamic
Standby adapter
Select one adapter to be set to standby mode from the adapters in the team.
Setting all adapters to active mode is also possible.
Express5800/R310g-E4, R320g-E4, R320g-M4 Maintenance Guide (Windows)
Configures static aggregation between the NIC and switches.
Configures teaming on the NIC side without depending on the switch
settings.
Configures dynamic aggregation between the NIC and switches.
Important Select other than Static Teamin for teaming mode when connecting 100Mbps or
10Mbps.
If select Static Teaming and connect with 100Mbps or 10Mbps, network
communication may be disabled when the module degraded.
Distributes the load based on IP addresses and port numbers.
Distributes the load to each of the virtual switch ports used by the
virtual machines.
 Distributes the load based on IP addresses and port numbers in
sending.
Distributes the load same to "Hyper-V Port" in receiving.

3. Duplex LAN Configuration
143