NEC Express5800/R320g-M4 Maintenance Manual page 62

Chapter 1 Maintenance
(1)
Error messages
Error Message
8000 System variable is
corrupted.
8001 Real time clock error
8002 Check date and time
settings
8006 System configuration
data cleared by Jumper.
8007 SETUP Menu Password
cleared by Jumper.
8800 DXE_NB_ERROR
8801 DXE_NO_CON_IN
8802 DXE_NO_CON_OUT
8803 PEI_DXE_CORE_NOT_FOUND
8804 PEI_DXEIPL_NOT_FOUND
8805 DXE_ARCH_PROTOCOL_NOT_A
VAILABLE
PEI_RESET_NOT_AVAILABLE The system was not reset correctly.
8806
8807 DXE_RESET_NOT_AVAILABLE
DXE_FLASH_UPDATE_FAILED The Flash ROM was not written to
8808
B000 Expansion ROM not
initialized
B001 Expansion ROM not
initialized - PCI
Slot 1
B002 Expansion ROM not
initialized - PCI
Slot 2
B003 Expansion ROM not
initialized - PCI
Slot ３
B004 Expansion ROM not
initialized - PCI
Slot ４
B022 Serial Port
Configuration
Overlapped.
B800 DXE_PCI_BUS_OUT_OF_RESO
URCES
C010 The error occurred during
temperature sensor
reading
C011 System Temperature out of
the range.
Express5800/R310g-E4, R320g-E4, R320g-M4 Maintenance Guide (Windows)
62
Description
Illegal setup information of BIOS was
detected.
Real time clock error was detected.
Incorrect date and time set on real time
clock was detected.
The setup utility settings were cleared
using the jumper.
The setup utility password was cleared
using the jumper.
An error was detected during
initialization of chipset.
An error was detected during
initialization of console.
A flash ROM is corrupt.
correctly.
Failed to expand option ROM.
Option ROM expansion in PCI slot 1
failed.
Option ROM expansion in PCI slot 2
failed.
Option ROM expansion in PCI slot 3
failed.
Option ROM expansion in PCI slot 4
failed.
Overlapping serial port configuration
was detected.
Resources to be allocated to PCI
expansion card was insufficient
An error was detected while reading
temperature sensor.
A temperature abnormality was
detected.
Action
Start BIOS Setup Utility (SETUP), and then
select Load Setup Defaults and specify the
necessary settings.
Start SETUP, and then specify the correct date
and time.
Follow the steps described in Chapter 1 (10.
Resetting and Clearing the Server).
Contact your sales representative.
Disable expansion of option ROM of the board
that is not used for OS boot.
Disable expansion of option ROM of the option
board that is not used for OS boot.
Start SETUP, and select Advanced  PCI
Configuration  PCI Device Controller and
Option ROM Settings  PCIx Slot Option
ROM  Disabled. (x: PCI slot number)
Start SETUP, select Advanced  Serial Port
Configuration, and specify the setting again in
a way that the values of Base I/O or Interrupt in
Serial Port A and Serial Port B will not be the

same.
Check the option board connection.
Contact your sales representative.
It is possible that a cooling fan has failed or is
clogged.
Contact your sales representative.
6. Error Messages