NEC Express5800/R320g-M4 Maintenance Manual page 93

Chapter 1 Maintenance
Tips
The alerts

 The detail information of alert is displayed as "Unknown" depending on the alert.
The ft server utility

 If the tree is not be displayed correctly when you open the ft server utility immediately after the
startup, wait for a while, and then start the ft server utility again.
Module status is shown "BROKEN".

 PCI modules (IO modules) and modules under the SCSI enclosure affect each other.
For example, when the "Status" item of a module changes to "BROKEN", it may be caused by
other module error. Check the status of the other modules referring to alert message.
Various logs cannot be referred in ESRAS Utility.

 ESRAS Utility is not used with this server model.
The status of network port is displayed as an error.

 If a network port is not used (not connected to cable), set it to "Disable" in Network
Connections from Control Panel. If the network ports to be disabled has dual LAN settings
(AFT function), remove the dual LAN settings before disable it.
Alert notification of monitored events

 In SNMP alert, the message text length is limited to 511 bytes. If the message text exceeds 512
bytes is sent, you need to verify the full length message on Event Viewer of sender machine. To
display the message text exceeding 512 bytes on Alert Viewer, use TCP/IP In-Band.
Since the message text exceeds 511 bytes when CPU or PCI module is degraded, you need to
verify ESMFTPolicy event on the sender machine.
Express5800/R310g-E4, R320g-E4, R320g-M4 Maintenance Guide (Windows)

If the status is "Empty", the module is not mounted. Sensor monitoring is not
conducted.

If disks are mounted on CPU/IO modules, the status of both modules is "Simplex"
while the disks are mirrored. Temperature or voltage error occurring during disk
mirroring will result in the system to shut down.
8. Troubleshooting
93