Quitting The Sas Configuration Utility; Physical Formatting Of The Hard Disk Drive - NEC Express5800/R320g-M4 Maintenance Manual

Chapter 3 Useful Features
3.2

Quitting the SAS Configuration Utility

Take procedures below to quit the SAS Configuration utility.
1. Keep pressing the <Esc> key until the menu shown below appears.
2. Select Discard changes and reboot or Exit the Configuration Utility and Reboot from the menu, and
press the <Enter> key.
3. Run the BIOS setup menu after the rebooted (see Chapter 3 (1.1 Starting SETUP)).
4. Select UEFI from Boot mode from Boot menu.
5. Select Save Changes and Exit from Save & Exit menu, save the settings and then reboot.
3.3

Physical Formatting of the Hard Disk Drive

The following describes how to execute physical formatting of hard disk drive.
1. Press the <Enter> key on the Adapter List menu.
Adapter Properties menu appears. Select SAS Topology and press the <Enter> key.
Express5800/R310g-E4, R320g-E4, R320g-M4 Maintenance Guide (Windows)
232
Are you sure you want to exit ?
Cancel Exit
Save changes and reboot.
Discard changes and reboot.
Exit the Configuration Utility and Reboot
Do not change the settings on the SAS Configuration. If you changed the settings, select
Tips
Discard changes and reboot to finish the utility.
This utility is set for the CPU/IO module of the primary side. When you
Important
configure the CPU/IO module of the secondary side, first power off the
server, plug out and plug in the AC power cord of the primary side. Then
start the server.
3. SAS Configuration Utility