Intelligent Inspection - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
Tab
----End

6.17 Intelligent Inspection

Prerequisites
Devices such as the camera, sound pickup, and AC actuator have been connected
to the ECC800-Pro.
Procedure
Step 1 Log in to the ECC800-Pro WebUI as an administrator.
Step 2 Choose System Settings > System Parameters > Site Configuration, set System
type to General, and click Submit. Enter the login password of the current user
and click Submit. After the system restarts, log in to the system again.
Issue 04 (2021-10-09)
Parameter Description
Lifter run info Clears the running times, mileage, and time of the
reset lifter.
PTZ height Specifies the PTZ height.
PTZ move After this parameter is set, the PTZ continuously moves
control leftward, rightward, upward, or downward until a stop
command is delivered.
PTZ horizon Specifies the horizontal angle of the PTZ.
position
PTZ vertical Specifies the vertical angle of the PTZ.
position
PTZ self test Runs PTZ self-test.
PTZ recover Recovers the horizontal and vertical angles of the PTZ
position to 0 degrees.
PTZ camera The camera continuously zooms in or out until a stop
zoom control command is delivered.
PTZ camera The focal length of the camera keeps changing until a
local length stop command is delivered. (You are advised to set this
control parameter in manual focus mode.)
PTZ camera Specifies the zoom of the camera.
zoom
PTZ camera Specifies the focal length of the camera. (You are
local length advised to set this parameter in manual focus mode.)
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
280