What Should I Do If A Message Indicating Unauthorized Fingerprint Is Displayed During Fingerprint Scanning On The Access Control Device (Fingerprint Has Been Recorded) - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
Press and hold down the SW button for 1 minute to restore factory settings and
clear user information. Exercise caution when performing this operation.
Figure 8-25 SW button
----End
8.24 What Should I Do If a Message Indicating
Unauthorized Fingerprint Is Displayed During
Fingerprint Scanning on the Access Control Device
(Fingerprint Has Been Recorded)?
Procedure
Step 1 Ensure that no obstacles exist in front of the fingerprint, and then scan the
fingerprint on the access control device again.
Step 2 If the message is still displayed after you perform
fingerprint information.
1.
2.
3.
Step 3 If the message indicating unauthorized fingerprint is still displayed after you
perform
1.
2.
----End
Issue 04 (2021-10-09)
WARNING
Choose System Settings > Access Management. On the Authorization
Operations tab page, click Synchronize to Device, select the device for
synchronizing fingerprint information, and click Start Synchronization.
After the Synchronization Status of the device becomes Synchronized, close
the Synchronize Access Permission page.
Scan the fingerprint on the access control device again.
Step 1 and Step
Choose System Settings > Access Management.
Select the involved user and record the fingerprint again.
Copyright © Huawei Technologies Co., Ltd.
2, you need to record the user's fingerprint again.
Step 1, synchronize the
8 FAQ
366