Commissioning A Door Status Sensor (Connected To The Ai/Di Port On The Uim20A Expansion Module) - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
----End
6.4.1.3 Commissioning a Door Status Sensor (Connected to the AI/DI Port on
the UIM20A Expansion Module)
If a door status sensor is installed, perform the following steps to configure it.
Context
●
●
●
Procedure
Step 1 Set parameters for a door status sensor.
1.
2.
3.
4.
5.
6.
7.
8.
Step 2 Check the door status sensor functions.
Table 6-8 Function check
Check Method
Open the cabinet door.
Issue 04 (2021-10-09)
To use the AI/DI sensor, enable the corresponding AI/DI port and name the
sensor. After that, the specific alarm can be reported.
If the sensor is prefabricated, only check its settings.
If multiple door status sensors are connected, commission one door status
sensor first and then commission the other door status sensors in the same
way.
NO TE
In this example, the door status sensor is connected to the AI/DI_1 port on the user
interface module1.
Log in to the ECC800-Pro WebUI as an administrator.
Choose System Settings > Signal Name Modify. The Batch Signal
Configuration page is displayed.
Set Device Type to UIM, set Device Name to UIM1, and click OK.
On the query result tab page, set the new signal name of AI/DI_1 to Door1
and click Submit.
NO TE
Order number of door sensor name is same as cabinet.
Choose Monitoring > System > UIM Group > UIM1 > Running Parameters
> AI/DI_1 Port Settings.
Set Door1 sensor to Enable and click Submit.
Set Door1 sensor type to Door sensor, ensure that Door1 power supply is
Yes, and click Submit.
Perform the preceding operations to set parameters for ports AI/DI_2 to AI/
DI_8.
Copyright © Huawei Technologies Co., Ltd.
Normal Connection Status
Door1 DI alarm is generated on the active
alarm page of the app or WebUI.
6 Feature Description
135