Commissioning A Door Status Sensor (Connected To The Ai/Di Port On The Uim20A Expansion Module) - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Table 6-9 Function check
Check Method
Close and then open the door.
----End
6.4.1.3 Commissioning a Door Status Sensor (Connected to the AI/DI Port
on the UIM20A Expansion Module)
If a door status sensor is installed, perform the following steps to configure it.
Context



Procedure
Step 1 Set parameters for a door status sensor.
1.
2.
3.
4.
5.
6.
7.
8.
Step 2 Check the door status sensor functions.
Issue 06 (2020-04-22)
To use the AI/DI sensor, enable the corresponding AI/DI port and name the sensor. After
that, the specific alarm can be reported.
If the sensor is prefabricated, only check its settings.
If multiple door status sensors are connected, commission one door status sensor first
and then commission the other door status sensors in the same way.
In this example, the door status sensor is connected to the AI/DI_1 port on the user interface module1.
Log in to the ECC800-Pro WebUI as an administrator.
Choose System Settings > Signal Name Modify. The Batch Signal Configuration
page is displayed.
Set Device Type to UIM, set Device Name to UIM, and click OK.
On the query result tab page, set the new signal name of AI/DI_1 to Door1 and click
Submit.
Order number of door sensor name is same as cabinet.
Choose Monitoring > System > UIM Group > UIM1 > Running Parameters >
AI/DI_1 Port Settings.
Set Door1 sensor to Enable and click Submit.
Set Door1 sensor type to Door sensor, ensure that Door1 power supply is Yes, and
click Submit.
Perform the preceding operations to set parameters for ports AI/DI_2 to AI/DI_8.
Copyright © Huawei Technologies Co., Ltd.
Normal Connection Status
If the alarm is enabled for the front and rear doors, a
cabinet door open alarm is displayed on the active
alarm screen of the app or the active alarm page of the
WebUI.
6 Feature Description
123