Control Function Of An Infrared Remote Control Module - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Step 2 Add the infrared remote control module.
1.
2.
Table 6-35 Parameters for adding an infrared remote control module
Path
System
Settings >
Device
Management
3.
----End

6.7.3 Control Function of an Infrared Remote Control Module

Prerequisites



Issue 06 (2020-04-22)
The address of the infrared remote control module is set to 2 by default.
Log in to the ECC800-Pro WebUI as an administrator.
Add an infrared remote control module and click Add Device.
Parameter
Device type
Connect to
Communications
port
Device address
Click Connect Test to check the connectivity between the infrared remote control
module and the ECC800-Pro.
a. If the connection is normal, click Confirm.
b. If the connection is abnormal, check whether the device is properly connected to the
ECC800-Pro, whether both are running properly, and whether the parameter
settings are consistent with the device parameters.
The infrared remote control module is connected to the ECC800-Pro, and both are
powered on.
You have obtained the IP address of the ECC800-Pro as well as the user name and
password used for WebUI login.
You have prepared a PC with an IP address in the same network segment as that of the
ECC800-Pro, and the PC is connected to the WAN port on the ECC800-Pro.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select Infrared remote control module from the
drop-down list box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
Connect the T/H sensor to the COM1 port on the
ECC800-Pro, and cascade the T/H sensor to the infrared
remote control module. If the T/H sensor is connected to
another port, enter the number of the connected port.
In this example, Device address is set to 2. Set the
actual device address of the infrared remote control
module during operations.
6 Feature Description
171